Tascam CD-01U Manuel d'utilisateur télécharger pdf (Page 24)

External parallel control

Restoring factory default settings

7 - Advanced operations

The CD-01U Pro can be controlled from an external

devices which supports a parallel interface via the CON-

TROL I/O terminal on the rear panel.

Pin No. Description In/Out

1 Stop tally Out

2 Skip (Back) In

3 Skip (Forward) In

4 No Disc tally Out

5 EOM tally Out

6 Search (Back) In

7 Search (Forward) In

8 GND

9 Play tally Out

10 Pause tally Out

11 Fader start/stop In

12 Stop In

13 Play In

14 Pause In

15 +5V

In:

Input signals are active when low (ground) for > 30 ms.

Out:

Tally signals are open collector, with a maximum current of 50 mA.

+5V:

The maximum current supplied from this terminal is 50 mA.

24 TASCAM CD-01U/CD-01UPro

Event start

Connect the RELAY IN jack (mini jack) on the rear panel

and event start terminal on the external device which

supports the event start function.

The relay play menu (menu number 06 RELAY) should

be set to ON.

REMOTE(PARALLEL)

To restore all settings to their factory defaults:

1 Select the factory preset menu (menu number 14 F-

PRE).

2 The display shows 14 flashing, then press the PITCH

knob on the front panel or ENTER key on the remote

control to confirm the selection.

3 The display shows - SURE - flashing to recomfirm

that this operation is surely desired.

4 Press the PITCH knob on the front panel or ENTER

key on the remote control to restore all settings to

their default values.

The following settings are restored to default values.

≠ Playback mode

≠ Time display mode

≠ Auto ready

≠ Auto cue

≠ Pitch control value

≠ All menu settings

You can cancel to restore the default settings either the

stage 14 F-PRE or SURE is flashing by pressing the

other keys except the SHIFT key and the PITCH knob

on the front panel.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Tascam CD-01U Manuel d'utilisateur Page 24

Commentaires sur ces manuels